【 Weak current College 】 ladder basic type tilt and lift height

Available 27.3o, 30o, 35o three inclination to choose from. In the same lifting height, 27.3o escalator required space than 30o escalator, which is better than 30o 35o.
Basic types of escalator

Tilt angle and lifting height:

Available 27.3o, 30o, 35o three inclination to choose from. In the same lifting height, 27.3o escalator required space than 30o escalator, which is better than 30o 35o.

35o-ladder is the most economical package, except for a small space, its manufacturing costs are lowest, this escalator used for shopping. 30o escalator is widely used in public places, but sometimes 35o escalator can also be used, such as space is limited or when planning a restricted site.

If used in conjunction with the staircase stairs fixed staircase, in order to conform with the standard steps, you need to use the escalator 27.3o, but in any case this type is only needed in special offer.

Ladder step width:

Equipped with 60, 80, 100cm three steps widths to choose from, in the passengers often mobile goods flow of peak areas, it is obvious to choose landing width 100cm escalator.

In hotels, banks and shopping centre, beautiful and comfortable are material. In shopping centres, if steps width is too small, the customer had to put the package mentioned handrails or standing at the edge, this is very dangerous to the safety and comfort, wide steps is particularly important.

For these reasons, in the small shopping centre in our selection of minimum landing width 80cm, shopping malls, we take steps width 100cm.

In order to avoid local traffic jams, in continuous use escalators when stairs width should in principle be the same, as an exception, only a gradual reduction in passenger traffic, the subsequent escalator steps width decreases.

From the artistic point of view, hotels, banks and general social utilities in the ladder should be as wide as possible.

Ladder horizontal transport section

Horizontal transport period refers to from entering the front of the landing or exit ladders of rear horizontal distance running. This distance in EN115 standards clear definition, the determination of the distance is based on the ladder of running speed and vertical lifting height.

According to the length of the horizontal transport segment, we have three escalators.

The "K" = 2 horizontal steps according to the provisions of the two EN115 telescopic height error in 4 mm

"M" = three horizontal ladders

"L" = 4 horizontal ladders

According to the provisions of EN115 when vertical lifting height greater than 6 meters or speeds greater than 0.5 m/s, the level of transport period not less than the M-type.

The arrangement of escalator

Continuous layout of ladder: (only single-direction)

Only used for smaller-scale shopping centers in three floors between runs.

Segmental arrangement: (only single-direction)

This arrangement on the customer is concerned, some not-too-convenient, do it on the main shopping centres is superior, because you can transfer the stairs on the way customers providing them with some special services.

Cross continuous layout:

Installed in many floors in the cross of continuous layout, escalator can serve two running direction, this format is usually used in shopping malls, and now also increasingly used in government agencies and public places, it can reduce the main floor of the run time.

Parallel, segment layout:

Two or more joint arrangement of escalator can, so you can easily while transporting passengers in both directions, at fastigium, must be based on traffic to change three or more computers running direction of the escalator.

The layout used for public transport architecture.