Weak current College】 【escalator elevator automatic sidewalk terminology.

1 scope of this standard provides for elevators, escalators, automatic sidewalk terminology. This standard applies to the development of standards, technical documents, writing and translation professional manuals, textbooks and books.
2 lift type
2, 1 elevator LIFT ELEVATOR service provision; the floors of stationary lifting equipment. It has a car that runs on at least two columns and vertical or tilting angle is less than 15 degrees between rigid rail. Cabin size and structure for easy passenger accessibility or goods.
2.1.1 passenger elevator PASSENGERLIFT for the transport of passengers and the design of the lift.

2.1.2 laden elevator GOODSLIFT; usually it was accompanied by FREIGHTLIFT, mainly designed for transporting goods elevator.
2.1.3 and freight elevator PASSENGER-GOODSLIFT mainly in the conveyance of passengers, but can also be transported cargo elevator.
2.1.4 beds elevator; medical elevator BEDLIFT for transporting beds (including patient) and medical equipment and design of the lift.
2.1.5 residential elevator RESIDENTIALLIFT for residential building with elevator.
2.1.6 service lift DUMBWAITERLIFT; SERVICELIFT service to provide fixed lifting device of the floor. It has a car cabin on its feet the rain and structure, the car is not permitted to enter. Car running on a two-column vertical or inclined angle of 15 degrees between rigid Rails. In order to satisfy the conditions, shall not enter the destination dimensions must not exceed: A) floor area: 1, 00M * MB) depth: 1; height: 1 00MC), 20M however, if the car cabin consists of several permanent interval, each interval is able to meet the above requirements, the height of more than 1, 20M is allowed.
2.1.7 shipboard elevator LIFTONSHIPS ship lifts.
2.1.8 sightseeing lift PANORAMICLIFT; OBSERTIONLIFT wells road and car wall at least the same side transparent, passengers can watch cars car location from the lift.
2.1.9 vehicle lift MOTORVEHICLELLIFT; AUTOMBILELIFT used for the conveyance vehicles designed for the elevator.
2.2 hydraulic elevator HYRAULICLIFT rely on hydraulic-driven elevator.
3 General terms
3.1 LEVELINGACCURACY leveling accuracy over the destination to the docking station, the cabin and on the plane and on the ground floor door plane vertical deviation value.
3.2 elevator rated speed RATEDSPEEDOFLIFT elevator design by car the car speed.
3.3 INSPECTIONSPEED elevator maintenance and repair speed runs.
3.4 rated load RATEDLOAD; RATEDCAPACITY elevator design by car within the maximum load.
3.5 elevator lifting height TRAVELINGHEIGHTOFLIFT; underlying LIFTINGHEIGHTOFLIFT from floor to top floor end station-station the vertical distance between the buildings.
3.6 room MACHINE installed one or more of its pull traction machine and ancillary equipment of private rooms.
3.6.1 room height MACHINEROOMHEIGHT room ground to the roof of the computer room minimum vertical distance.
3.6.2 room width MACHINEROOMHEIGHT engine along parallel to the cabin width direction of horizontal distance.
3.6.3 room width MACHINEROOMDEPTH room perpendicular to the horizontal distance from the room width.
3.6.4 room area MACHINEROOMAREA room width and depth of the product.
3.7 auxiliary room; insulating layers; pulley interval SECONDARYMACHINEROOM; SECONDARYFLOOR; PULLEYROOM rooms well road, room floor and wells road, between the top of the room. It features a cubicle, you can install the pulley, the speed limiter and electrical equipment.
3.8 layer by ticket LANDING on each floor for access-car sites.
3.9 layer station entrance LANDINGENTRANCE in Wells road collision of at least part of it from the station to the car between the channels.
3.10 base station MAINLANDING; MAINFLOOR; HOMELANDING cabin no operational instruction dock station. General is located in the lobby or back-end up standing passengers.
3.11 scheduled base station PREDETERMINEDLANDING parallel or group control control of elevator car no run command, the specified docking stand-by operation of the station.
3.12 underlying end station BOTTOMTERMINALLANDING lowest car docking station.
3.13 top-level end station TOPTERMINALLANDING highest car docking station.
3.14 FLOORTOFLOORDISTANCE interlayer distance; INTERFLOORDISTANCE two adjacent dock station-the distance between the door and sill.
3.15 well pretend WELL; SHAFT; car and HOISTWAY on reloading or (and) hydraulic cylinder piston movement in the cellar. This space is well road pit bottom wells road pit bottom wells road wall and wells road, top-shelf.
3.16 single ladder wells road SINGLEWELL for elevators running well road.
3.17 lot stairwell road MULTIPLEWELL; COMMONWELL for two or two above the elevator runs well road. ]
3.18 wells road wall WELLENCLOSURE; SHAFTWELL used to separate wells road and other places of the structure.
3.19 wells road width WELLWIDTH; SHAFTWIDTH parallel to the cabin width direction well road wall the horizontal distance between the surface.
3.20 wells road depth WELLDEPTH; SHAFTDEPTH perpendicular to the direction of the shaft well road width of the road surface in the wall the horizontal distance between.
3.21 pit PIT bottom end station floor following wells road section.
3.22 pit depth PITDEPTH by underlying end station floor to Wells road, pit the vertical distance between the floor.
3.23 top height HEADROOMHEIGHT; HEIGHTABOVETHEHIGHESTLEVELSERVED; top-end station TOPHEIGHT from floor to ceiling, well road under most prominent vertical distance between the components.
3.24 wells road inner bracket; haunched beam HAUNCHEDBEAM is located on all floors of the station entrances inside well road, below for support layer door and sill are projecting of buildings.
3.25 surrounding well TRUNK of shipboard elevator shafts.
3.26 surrounding well export HATCH in shipboard elevator Wai Inoue, horizontal or vertical set of door.
3.27 unlock car car dock area UNLOCKINGZONE layer station in Kham, extension of range. When the cabin floor in this area can only be opened when the door to door machine movements, driving car door, door.
3.28 leveling LEVELING in leveling range, so that the cabin doors to Campo and layers to achieve the same plane of Kham.
3.29 leveling area LEVELINGZONE cabin stops above and/or below a limited area. In this area you can use the leveling device to keep the car running reached level requirements.

3.30 door width DOOROPENINGWIDTH cabin door and the floor of the waterway fully opened the door.
3.31 cabin entrance CARENTRANCE in car wall at parts, it constitutes from car to layer between the normal channel.
3.32 cabin inlet dimension CLEARENTRANCETOTHECAR car arrived at the stop, car doors fully opened, the measured width and height of the gate.
3.33 cabin width CARWIDTH parallel to the cabin entrance width direction from the bridge cabin floor 1M height measured car wall two inner surface of the horizontal distance between.
3.34 cabin depth CARDEPTH perpendicular to the direction of the cabin width, pitch car bottom 1M height measured car wall between the two inner surface.
3.35 cabin height CARHEIGHT from car floor to the measured inside the car the vertical distance between the top (the cabin roof shade and removable ceiling in the distance).
3.36 lift drivers LIFTATTENDANT specially trained, qualified action card authorization handling elevator.
3.37 passengers NUMBEROFPASSENGER elevator design qualified up to passengers (including driver).
3.38 working stroke WORKINGSTROKEOFOILBUFFER absorber shock absorber piston-compression of the movement of vertical distance.
3.39 spring buffer working stroke WORKINGSTROKEOFSRINGBUFFER spring compression deformation of vertical distance.
3.40 car bottom clearance BOTTOMCLEANCESFORCAR when the car is fully compressed buffer position, from the pit floor to install in the cabin under the Department of the lowest widget vertical distance (minimum component does not include import boots, wheel, safety, and guarding the soles).
3.41 car top clearance TOPCLEARANCESFORCOUNTERWEIGHT when the counterweight in the fully compressed buffer position, from car top highest part to Wells road, the vertical distance from the lowest part.
3.42 the top clearance TOPCLEARANCESFORCOUNTERXEIGHT when the car is fully compressed buffer location to reload the highest portion to the top of the lowest part of the well road vertical distance.
3.43 docking procedures DOCKINGOPERATION under specific conditions, in order to facilitate the loading and unloading of cargo freight elevator, car door and the door is opened, the layer so that the car up from the bottom station, the required distance to run at low speed, with touches of cargo equipment.
3.44 casing dock operation SKIP-STOPOPERATION adjacent two elevators one Office-ladder, one elevator service to an even number of tier points, while another elevator service to odd layer station operation.
3.45 maintenance practice INSPECTIONOPERATION
3.46 lift drag cited type TRACTIONTYPESOFLIFT pulled traction machine-driven elevator, room above the well road for top drag cited type; when rooms well road side to side pulled cited type.
3.47 elevator machine rope drag drag cited HOISTROPESRATIOOFLIFT suspension car number of wire rope and dragged cited round number unilateral wire rope.
3.48 fire service FIREMANSERVICE manipulation fire switch enables the elevator inputs firemen dedicated State.
3.49 independent operation INDEPENDENTOPERATION rely on key lock switch to manipulate the cabin interior button to make car lift operation.
4 elevator parts
4.1 buffer BUFFER is located in the stroke end, used to absorb the cabin the kinetic energy of an elastic buffer security appliance.
4.1.1 hydraulic buffer; energy-bufferHYDRAULICBUFFER; OILBUFFER to oil as a medium absorption cabin or to produce the kinetic energy of the buffer.
4.1.2 Spring buffers; energy storage buffers with SPRINGBUFFER to spring deformation to absorb cabin or to produce the kinetic energy of the buffer.
4.2 vibration apparatus VIBRATINGABSORBER used to reduce vibration and noise of the elevator runs.
4.3 cabin CARLIFTCAR carriage of passengers or other load of car body parts.
4.3.1 car bottom; car bottom CARPLATRORM; PLATFORM at the bottom of the car, the bearing load components. It includes floor, framework, etc.
4.3.2 car wall; car wall CARENCLOSURES; CARWALLS by metal plates and the cabin floor, the cabin top and cabin doors surrounded a closed space.
4.3.3 car cabin roof; car top CARROOR upper portion of the car with a certain strength requirements.
4.3.4 cabin decorative top CARHANDRAIL cabin top decoration parts inside.
4.3.5 car handrail CARHANDRAIL seated in the cabin on the wall of the handrail.
4.3.6 car top protective railing CARPROTECTIONBALUSTADE sets in car top upper part on maintenance staff play a protective role of the widget.
4.4 cabin frame; car rack CARFRAME fixed and support bridge cabin frame.
4.5 access door DOOROPERATOR makes the car door and (or) layer door open or closed.
4.6 access door opening in Wells road ACCESSDOOR, leads to the pit or pulley room for maintenance personnel use the door.
4.7 manual door MANUALLYOPERATEDDOOR used human switch car door or layer.
4.8 automatic door on the power switch POWEROPERATEDDOOR car door or layer.
9 floor doors; door LANDINGDOOR; the Office; HALLDOOR sets SHAFTDOOR station entrance door.
4.10 fire layer; fire door RIER-PROOFDOOR can prevent or delay the glowing gas or flame through the door of a layer.
4.11 cabin doors; door CARDOOR settings in the cabin entrance doors.
4.12 safety edge SAFETYEDGESFORDOOR in car door closing process, when a passenger or obstructions touch, car door reopening of mechanical door protection device.
4.13 hinge doors; flaring door on the side of the door HINGEDDOOR to hinge, by Wells road direction to the channel layer door opened.
4.14 door COLLAPSIBLEDOOR can folding, close to the fence in the shape of the cabin door.
4.15 horizontal sliding door HORIZONTALLYSLIDINGDOOR along the door guides and ground Ridge trough levels slip-resistant floor door.
4.15.1 CENTEROPENINGDOOR layer in door doors or car door, the door in the middle of their respective left and right to the same speed of the open door.
4.15.2 the door; double folded next door; the two-speed doors TWO-SPEEDSLIDINGDOOR; TWO-PANELSLIDINGDOOR; TWOSPEEDDOOR layer gate or door of two doors to two different speeds on the same side of the open door.
4.15.3 left door LEFTHANDTWOSPEEDSLIDINGDOOR facing cabin, the left direction to open the door of the layer or the car door.

4.15.4 right cabin door RIGHTHANDTWOSPEEDSLIDINGDOOR face, the direction to the right of the tiers door or opening car door.
4.16 vertical sliding doors on both sides along the door VERTICALLYSLIDINGDOOR vertical sliding door track opened.
4.17 vertical door BI-PARTINGDOOR layer in doors or door of two doors in the middle of the door to the same speed, up their opened.
4.18 pulled cited rope compensator COMPENSATINGDEVICEFORHOISTROPES used to balance because of the elevator lifting height too high, causing excessive drag cited rope running too much emphasis on the phenomenon of the parts.
4.19 compensation chain consisting of compensating device. With a metal chain consisting of compensating device.
4.20 compensation rope ropes for apparatus COMPENSATINGROPEDEVICE some tension wheel components of compensation device.
4.20.1 compensation rope hold-down device ANTI-REBOUNDOFCOMPENSATIONROPEDEVICE when compensation rope tensioning device exceeds the limit position, can pull machine to spin down electrical safety devices.
4.21 ground Ridge SILL cabin entrance door or layers into and out of the car's slotted metal pedal.
4.21.1 cabin to Campo CARSILLS; PLATETHRESHOLDELEVATOR cabin entrance to Campo.
4.21.2 layer door to Campo LANDINGSILLS; SILLELEVATORENTEANCE layer door entrance to Campo.
4.22 jiaoding overhaul plant INSPECTIONDEVICEONTOPOFTHECAR settings in car top upper for maintenance personnel maintenance of equipment at the time of application.
4.23 car top lighting CARTOPLIGHT settings in car top upper for maintenance personnel maintenance of lighting appliances.
4.24 pit maintenance lighting LIGHTDEVICEOFPITINSPECTION settings in Wells road, pit, forMaintenance personnel maintenance of lighting appliances.
4.25 cabin in a layer of light; car position indicator CARPOSITIONINDICATOR settings within the cabin, display its appliance running the station.
4.26 layer door set LANDINGDOORJAMB decorative layer door frames widget.
4.27 layer door led LANDINGINDICATOR; HALLPOSITIONINDICATOR settings in the layer above or a side door, the show car run station and orientation of the device.
4.28 layer door direction indicators set in the layer LANDINGDIRECTIONINDICATOR over the door or side show car running direction of the device.
4.29 Control Panel CONTROLPANEL is independent of the bracket, brackets have metal insulated floor serices or beam, a variety of electronic and electrical components installed on the floor or on the beam of a once-electric control equipment.
4.30 control cabinet CONTROLCABINET; various electronic devices and electric CONTROLLER components installed in a protective role of Cabinet profile structure of electronic control devices.
4.31 manipulation boxes; manipulate disk OPERATIONPANEL; CAROPERATIONPANEL for switch, button control car running electrical installations.
4.32 alarm button ALARMBUTTON